![]() and set the inform URL to the correct address: First, reset the Unifi AP with. will be saved after device is successfully managed The UAP AC Pro can be set up in minutes and fully managed with the UniFi. Therefore, if you enter the set-inform command and are not disconnected in a few seconds, you should assume the connection has failed and use the info command to see why.īusyBox v1.11.2 ( 14:53:48 PST) built-in shell (ash)Įnter 'help' for a list of built-in commands.ģ. Once the access point has successfully been adopted by the controller, you will be disconnected from your ssh PuTTY session and will not be able to connect in again as user ubnt.Otherwise, you will need to enter the set-inform command again Once the access point has been linked to your account, if you are using CNAME DNS it will autoconfigure.We will link the access point to your account. Therefore, please contact us to let us know the access is on and ready. However, the access point still needs to be adopted and assigned to your account. to ), the access point will send one request and, if the connection is successful, the controller will then know that the access point exists. If you have manually set the inform URL (e.g.Status: Unreachable if a firewall is blocking access to the controller.Status: Unable to resolve if you have entered the wrong address or DNS is not working (or CNAME is not configured).Status: Server Reject if the access point was able to contact the controller, but the controller has not yet adopted the access point - This is normal with a new access point.Test connectivity to controller with info and ping.If you have a UniFi Gateway, you should use the name or IP address of that instead of. To manually configure it, you will need to set explicitly with the following command. if you have a A or CNAME DNS record it will find the controller). UniFi Command Line Interface - Ubiquiti Networks Enter username as ubnt and password as ubnt.If you see a warning like the following, click Yes:. ![]() Enter IP address in Host Name box and click Open:.The access point's MAC address is displayed on its underside. Your DHCP server will probably tell you this. Wait for it to reboot (flashing white light).Reset the AP by holding down the reset button for 10s.Connect Access Point to power and network similar to the procedure described in setting up the demo equipment.
0 Comments
Leave a Reply. |